Power inverters, jacks, lifting equipment and workshop hardware.
A car raised on a hydraulic trolley jack. Photo by Vitaly Barsov (Snowleopard), CC BY-SA 3.0, via Wikimedia Commons. Every 4-ton floor…
Read More →
Photo by Greg Gjerdingen, licensed CC BY 2.0. A high lift jack is the only jack in most garages that can also…
Read More →
Photo by MercurySable99, licensed CC BY-SA 4.0. A loaded Ram 3500 can carry a GVWR up to roughly 14,000 lb, and a…
Read More →
Photo by EastEliteLiftingEquipment, licensed CC BY-SA 4.0. Almost every electric pallet jack in this class runs on a 24V system, so “24V”…
Read More →
A static wedge ramp gives you one fixed angle and height. A hydraulic car ramp drives onto a low base and lifts…
Read More →
RhinoGear rates its ramps up to 16,000 lb GVW, but most standard ramps use a 17-degree incline that will scrape a lowered…
Read More →
RYOBI's "1000-Watt" ONE+ inverter caps at 300W from an 18V battery — the full rating only applies when clamped directly to a…
Read More →
A 3000W inverter draws about 250 amps at 12V. Most stock truck alternators cannot sustain that alongside everything else running. Here is…
Read More →ESCO's low-profile bladder jack still starts at 7.9 inches. Triple-bag units start around 4.5. Low-profile hydraulic jacks start at 2.5. If your…
Read More →Two pallet jack wheels can look identical and have different bores. Measure outside diameter, width and bore before ordering, know your bearing…
Read More →Milwaukee publishes pure sine wave output for the MX FUEL CARRY-ON but not for the M18 TOP-OFF. That gap matters if you…
Read More →Two completely different tools share the name air bag jack. One inflates from your exhaust to free a stuck truck; the other…
Read More →